Galvanostatic Pages

The standard Galvanostatic analysis contains the following pages at startup:

Chart The Chart page is the heart of the Differential Pulse analysis. It contains the data plotted as Idifference versus Vforward.
Experimental Setup

The Experimental Setup page contains a list of the parameters used to acquire the data presented on the Chart page.

Experimental Notes The Experimental Notes are the notes you entered prior to the data-acquisition. The Notes can be edited in the analysis, and saved with the changes to an analysis data file.
Hardware Settings

The Hardware Settings page contains all of the potentiostat settings used during the run of the experiment.

Electrode Settings

The Electrode Settings page contains all of the electrode settings used during the run of the experiment. This page specifies if the experiment was a stripping experiment.

Additional Pages Which May Become Visible

Min/Max This page contains a grid of minimum and maximum values of each visible trace based on the most recent use of the Min/Max command.
Peak Locations

This page contains a grid of peak locations and magnitudes based on the most recent use of the Peak Find command.