Galvcor.Thresh()

Type: INSTANCE FUNCTION

Purpose: Set up threshold conditions which must be met before Galvcor.StopAt() tests are performed.

When any of the threshold tests is met, the StopAt criteria are evaluated for the rest of the scan. There are six threshold tests that you can perform:

1. IMin

I < I_MinThresh

2. IMax

I > I_MaxThresh

3. EMin

E < E_MinThresh

4. EMax

E > E_MaxThresh

5. Tmin

T < T_MinThresh

6. Tmax

T > T_MinThresh

Threshold tests allow you to tune the StopAt tests more carefully. For example, you can avoid a premature experiment termination caused by an initial transient.

In general you only enable one of the threshold tests. The others are turned off by a NIL argument in the function call.

Note: Any threshold test starts all StopAt tests. Also, when StopAt testing is enabled, it is never disabled, even if the Threshold test that enabled it is no longer valid.

Usage:

Galvcor.Thresh(IMin, IMax, EMin, EMax, TMin, TMax)
       
Imin   REAL

Enable StopAt if I < IMin

  or NIL Disable this test.
Imax   REAL Enable StopAt if I > IMax
  or NIL Disable this test.
EMin   REAL Enable StopAt if E < EMin
  or NIL Disable this test.
EMax   REAL Enable StopAt if E > EMax
  or NIL Disable this test.
TMin   REAL Enable StopAt if T < TMin
  or NIL Disable this test.
TMax   REAL Enable StopAt if T > TMax
  or NIL Disable this test.

Related Topics Link IconRelated Topics