Requires StopAt criterion be met for a number of data points (N) before the curve stops. The parameter N can be individually set for each StopAt test.
For absolute tests, such as I > Limit, the criterion must be met for N points consecutively before the criterion is accepted. One point missing the criterion limit resets the N point counter.
For slope tests, such as dE/dt < Limit, the slope is evaluated over N points.
Cpiv.StopAtDelay(Under, Over, Stable, Runaway, Decreasing, Increasing) | |||
Under | or | REAL |
Delay for this number of points. |
NIL | Only one point required. | ||
Over | or | REAL | Delay for this number of points. |
NIL | Only one point required. | ||
Stable | or | REAL | Delay for this number of points. |
NIL | Only one point required | ||
Runaway | or | REAL | Delay for this number of points. |
NIL | Only one point required | ||
Decreasing | or | REAL | Delay for this number of points. |
NIL | Only one point required | ||
Increasing | or | REAL | Delay for this number of points. |
NIL | Only one point required |