Pages

The standard potentiodynamic analysis contains the following pages at startup:

Chart page The heart of the Potentiodynamic analysis. It contains the data plotted as voltage versus log(current) format.
Experimental Setup page A list of the parameters used to acquire the data presented on the Chart page.
Experimental Notes The notes entered by the user before data-acquisition. You can edit the Notes in the analysis, and saved with the changes to an analysis data file.
Open Circuit Voltage page Displays a chart of OCP vs time that was collected during the Initial Delay.
Hardware Settings Page All of the potentiostat settings used during the experimental run of the experiment.
  NOTE: THESE PAGES DO NOT APPEAR AT START-UP:
 

This page contains a grid of integration values based on different sections in visible traces from the most recent use of the Integrate command.

 

This page contains a grid of minimum and maximum values of each visible trace based on the most recent use of the Min/Max command.

 

This page contains a grid of corrosion rates, Ecorr, Icorr, and β information based on the most recent Tafel fit.

 

This page contains a grid of corrosion rates, Ecorr, Icorr, and β information based on the most recent Polarization Resistance fit.

 

This page contains a grid of corrosion rates, and Ecorr information based on the most recent E Log I fit.