Pages

The standard galvanic corrosion analysis contains the following pages at startup:

Chart page

The heart of the Galvanic Corrosion analysis. It contains the data plotted as current and voltage versus time.

Experimental Setup page A list of the parameters used to acquire the data presented on the Chart page.
Experimental Notes

The notes entered by the user before data-acquisition. You can edit the Notes in the analysis, and save with the changes to an analysis data file.

Open Circuit Voltage page Displays a chart of OCP vs time that was collected during the Initial Delay.
Hardware Settings page All of the potentiostat settings used during the experimental run.
  NOTE: THE PAGES BELOW ARE NOT DISPLAYED DURING START-UP.
 

This page contains a grid of integration values based on different sections in visible traces from the most recent use of the Integrate command.

 

This page contains a grid of minimum and maximum values of each visible trace based on the most recent use of the Min/Max command.